The Installation procedure is slightly different depending on the Garage button type.
Which Garage Button Type do you have?
I DONT KNOW
TYPE 1: Wire Push Button
Wire Push Button -
Older garage systems and newer low cost garage system often use simple wire push button. This type of garage system operating based on Resistive and Capacitive value to determine if the button is pressed.
Remove the garage button from the wall, open the front panel and you’ll see two wires (Usually Red and White) from the wall connecting to a circuit board. Inspect the Circuit board if its Simple then you have a Wire Push button.
Type 1 Wire Push Button has a simple circuit.
TYPE 2: Radio Push Button
Radio Push Button -
Some older garage system and more expensive garage systems often use radio push button. This type of garage system generate a radio signal to garage motor when the wall button is pressed.
Remove the garage button from the wall, open the front panel and take all look at the circuit board. If it looks very complex with many electronic components, then it is a Radio Push Button
Type 2 Radio Push Button has a more complex circuit board.