How to control multiple garages and add door sensors

Follow these steps to add a new sensor to the Fi Controller or to add back an sensor that was disconnected.

You must have a Fi Controller already setup with the app installed.

Mount the addition Door Sensor

Step 1: Open the garage fully.
Step 2: Tape the Sensor template 3 to 5 inches from garage door edge.
Step 3: Drill 2 holes on the sensor template.
Step 4: Mount the door sensor using the screws and butterfly nut provided.
Step 5:  Close the garage and unplug the garage motor.
Step 6:  Connect the door sensor with the provided Ethernet cable.
Step 7:  Connect the other end of the Ethernet cable to the power module .
Step 8:Unplug the trigger wires from the garage motor .
Step 9:Connect the trigger wires to the + and – terminal on the green power module terminal connector.
Step 10: Connect the trigger wire from the green power module terminal to the motor, replacing the trigger wires unplugged in Step 8.
NOTE: Keep note of wire color connected to + terminal.

 

Step 11: Mount the Power Module near the garage motor..
Step 12: Power it on,  The LED will be green meaning it is waiting to be paired.

 

Add the Door Sensor to the App

Step 12:Open up the app and Select Admin.
Note: You must be logged in as admin to view the Admin Menu. If your not admin, Please log out and log back in as admin. The password for admin is admin, unless you changed it in the Fi Controller.
Step 13: Select Add Fi Sensor.
Step 14: Setup
Step 15:You see the Network Setup Screen. Then go to Settings and tap on “WiFi”

Step 16:Look for the SencloSB-XXXX.
 
Step 17: Select the Senclo network and wait for the Check mark next to it before going back to Fi App.
 
Step 18:Go back to the Fi app and Click Setup.
 
Step 19:If it times out try again. Depending on your WiFi connection it may take a few tries. You will know it is successful when the Led on the Door Sensor is BLUE.
 
Step 20: BLUE means its connected.
 
Step 21:Check for newly added sensor in About.

 

Step 21: New Sensor is Added.
 
Step 22: Multiple Doors now. Swipe left for the new door.

 

Step 23: On the Fi Controller click on Door Select to toggle from door to door.
Step 24: Your on door 2 now. Click to open.