Fi Controller Installation for Garage Button Type 1

Fi Controller Installation for Garage Button Type 1

Before:
After:
Step 1: Open the garage fully.
Step 2: Tape the Sensor template 3 to 5 inches from garage door edge.
Step 3: Drill 2 holes on the sensor template.
Step 4: Mount the door sensor using the screws and butterfly nut provided.
Step 5:  Close the garage and unplug the garage motor.
Step 6:Unplug the trigger wires from the garage motor .
Step 7:Connect the trigger wires to the + and – terminal on the green power module terminal connector.
Step 8: Connect the trigger wire from the green power module terminal to the motor, replacing the trigger wires unplugged in Step 6.
NOTE: Keep note of wire color connected to + terminal.

 

Step 9:Mount the Power Module near the garage motor..
Step 10:Remove the garage button and the cables connected to it from the wall.
Step 11:Use the screws provided and dry wall anchor if necessary to install the wall mount where the garage button used to be.
Step 12:Connect the wire connected to + terminal in Step 8 to + terminal on mounting plate, and the other wire to – terminal on mounting plate.
Step 13: Place the fī controller onto the wall bracket using the top latch on the mounting plate then slowly push the unit into place. It will click when it is secure.  Use a mini screwdriver to tighten the screw at the bottom to lock the fī controller to the wall mount
Step 14:Plug the garage motor back in..
Step 15:Plug the power module DC adapter to the power outlet.
Step 16: The Fi Controller will Boot up and go to the WIFI Screen. Input your Home Wifi.
Step 17: The SENCLO light will turn blue, which means it’s connected to the internet.
Step 18:  Connect the other end of the Door sensor Ethernet cable to the power module.
Step 19:  Connect the door sensor with the provided Ethernet cable.
You will see it power up and the LED turn blue meaning it is connected to the Fi Controller.

 

Step 20:
You can now press the button on controller to open the garage
.

Click Here for the Fi Controller Software Installation guide